Search published articles


Showing 1 results for Heating-Cooling Cycle

Ahmad Jabari, Mehdi Hosseini,
Volume 13, Issue 5 (12-2019)
Abstract

In cases such as explosion, fire, deep drilling and geothermal energy extraction, rocks are exposed to high temperatures influencing the rock toughness. Thus, the aim of this study is to investigate the effect of temperature on the fracture toughness of the rocks. In this study, the effect of temperature on the mode I fracture toughness is investigated. To this end, three-point bending tests were performed on semicircular specimens of four types of natural rocks including sandstone, limestone, tuff, andesite, and a series of concrete specimens to determine the fracture toughness. The specimens were first heated to 100, 200, 300, 500 and 700 °C. After reaching the desired temperatures, the specimens were cooled. A series of tests was performed on the specimens at ambient temperature (25 °C). The heating rate in the electric furnace was 15 °C/min in accordance with the temperature rise in fires. Petrographic studies and X-ray diffraction analysis (XRD) were performed to identify the composition of the rocks. Furthermore, the effective porosity and the weight loss of heated specimens were determined to study the behavior of rocks. Comparison of the test results indicated the higher impact of temperature on the fracture toughness of fine-grained rocks. In addition, the fracture toughness decreased by increasing the effective porosity and decreasing the weight loss. According to the results, the mode I fracture toughness of sandstone, tuff, limestone, andesite and concrete specimens underwent a heating-cooling cycle up to 700 °C respectively decreased 45, 17, 44 and 9.5 and 37 percent compared with that of unheated specimens.
 



Page 1 from 1     

© 2024 CC BY-NC 4.0 | Journal of Engineering Geology

Designed & Developed by : Yektaweb