Journal of Engineering Geology

fa بررسی اثر شکل هندسی حوضۀ رسوبی و فرکانس موج تحریک بر پاسخ لرزه‌ای سطح زمین Study on Role of Basin Shape and Excitation Frequency on Seismic Response of Ground Surface ژئوتکنیک (مکانیک خاک و سنگ) Geotecnic مطالعه موردی Case-Study از آن‌جاکه اغلب شهرها در نزدیکی و یا روی درههای آبرفتی بنا شده‌اند، اثرهای هندسه حوضۀ رسوبی بر حرکت زمین در مهندسی ژئوتکنیک لرزه‌ای اهمیت ویژهای دارد. انحنای حوضهای که در آن خاکهای آبرفتی نرمتر رسوب‌گذاری شده ‌است، میتواند امواج حجمی را حبس کرده و موجب می‌شود که  برخی از امواج حجمی برخوردی، به‌صورت امواج سطحی در لایه آبرفتی منتشر شوند، این امواج می‌توانند لرزشهای شدیدتر و طولانیتری نسبت به آن‌چه در تحلیل یک بعدی با فرض انتشار قائم امواج برشی تخمین زده میشوند ایجاد کنند. در این پژوهش با استفاده از نرم افزار المان محدود آباکوس چهار شکل حوضۀ رسوبی شامل مستطیلی، ذوزنقهای، بیضی و مثلثی در حوزه زمان تحلیل شدند و اثر شکل هندسی حوضه رسوبی و هم‌چنین اثر محتوای فرکانسی موج تحریک در هر یک از حوضهها بررسی شد و نتایج آن با تحلیل یک بعدی مقایسه شد. نتایج نشان می‌دهد پاسخهای تحلیل یک بعدی با دو بعدی اختلاف بسیاری دارد این اختلاف تا 45/1 برابر پاسخ شتاب تحلیل دوبعدی به یک بعدی در حوضۀ مستطیل شکل است. مدل حوضه مستطیل شکل که در این تحقیق بررسی شده است  در مقایسه با سایر حوضهها پاسخهای بیش‌تری دارد.   Introduction Local site conditions considerably influence all characteristics of the ground strong motion including the domain, frequency content, and duration. The level of such an effect could be considered as a function of geometry, properties of the materials embedded in the underlying layers, the site topography, and properties of excitement. Site effect fall into two categories: a) the effect of the surface soft layers triggered by the shear velocity differences between the soil layers and b) the surface and subsurface topography effects that lead to the wave reflection and refraction based on the site geometry, and subsequently enhance the level of amplification. Since most cities have been constructed in the vicinity of or on sedimentary basins, geotechnical earthquake engineering devotes particular attention to effects of the sedimentary basins. Basin edge curvature deposited with soft soils are capable to trap the body waves and generated surface waves within the deposit layers. Such waves could create stronger and lengthier vibrations than those estimated in a 1D analysis that assumes the shear waves to be vertically propagated. Although critically important, the 2D effect of the site has not been included in seismic codes and standards of the world. This might be due to the fact that the site effect depends on a number of parameters such as the site geometry, the type of wave excitement, properties of the materials, etc. that in return make it almost out of the question to make predictions about the effect. This study was an effort to compare the responses of four sedimentary basins with hypothetical geometries of rectangular, trapezoidal, elliptical, and triangular shapes in order to examine the effect of the geometrical shape of the basin on its responses and the extent of the response sensitivity to the excitation frequency of the wave. The study assumed the edge to depth proportion to be both constant and equal in all four basins so that the effect of the geometrical shape could be equally examined and compared in all four basins.       Material and methods In order to validate the results of the sedimentary basin modeling, firstly, ABAQUS finite element software was used to create a free field motion of a semi-circular alluvium valley in accordance with Kamalian et al. (2006) and Moassesian and Darvinsky (1987).  Then, the results from the model were compared with those from the above mentioned studies. The following descriptions are to present the model in details. To evaluate the geometrical effect of the sedimentary basin on its response, the authors<a name="_GoBack"></a> relied on the software to examine four sedimentary basins with the fundamental frequency (2.04 Hz). The basins enjoyed rectangular, trapezoidal, elliptical, and triangular geometrical shapes with a constant edge to depth proportion (49m to 300m respectively). The implicit method was also applied to perform the dynamic analysis. The materials were all viscoelastic and homogeneous. The soil behavior/treatment model was considered to be of a linear nature.  The Rayleigh damping model was used to specify the damping level. The soil element was a plane strain and SV waves (the Ricker wavelet) were used for seismic loadings in a vertical dispersion. The side boundaries (right and left) of the model were of a combinational type (viscous and free field boundaries); the down side boundary was composed of viscous. To achieve higher levels of wave absorptions, heavy columns were used as the free filed columns. Next, it was the time to conduct the 1D analysis of the site. Three waves were in use in order to examine the effect of the frequency content of the excitation load on the basin response: 1) a wave with the dominant frequency of 1Hz that was out of the frequency range of all basins (2.04 Hz), a second wave with the dominant frequency of 2Hz that was close to the fundamental frequency of all basins, and a third wave with the dominant frequency of 4Hz. The waves were applied to a 2Dmodel. The results were compared with those obtained from a 1Dmodel in terms of the timing. Then, the basin responses to all three waves (1, 2, and 4 Hz) were subjected to an individual analysis in order to examine the sensitivity of each basin response to its geometrical shape. Results indicated that while the responses of the rectangular and trapezoidal basins were significantly more sensitive to the excitation frequencies, the elliptical and triangular basins showed more stable behaviors to such frequencies. The final stage of the study was dedicated to examine the site 2D effect during the ground motion. Results and Conclusions According to the results of the present study, it could be suggested that the geometrical shape of the sedimentary basin has a significant effect on the responses of the field of seismic waves and that it could result in so different responses from the ones attained after a 1D analysis of the site. In addition, the pattern of the seismic waves’ responses is highly dependent on the geometrical shape and the frequency content of the seismic load. Also, the location where the maximum horizontal acceleration occurs along with the sedimentary basin depends on the excitation wave and varies accordingly. Further, it could be suggested that the site 2D effect results in both considerable amplification and an increase in the length of ground motion. The results of the 2D analysis showed remarkable differences with their 1D counterparts: a 1.45 larger response for the rectangular basin, a 1.28 larger response for the trapezoidal basin, a 1.22 larger response for the elliptical basin, and a 1.19 larger response for the triangular basin. With the frequency of 1 Hz where the excitation frequency is out of the basin range (i.e. the excitation frequency is below the lowest frequency of basin), the sedimentary basin did not show any signs of amplification and chaos (unlike two other frequencies); instead, it was a cause for de-amplification. The frequency of 2 Hz that is subject to resonance resulted in amplifications (absent in 1D analysis) and there are traces of a reduction in the acceleration responses near to the edges of the basins. The proportion of the amplification (in the center of the basins) in 2D to 1D analysis was 1.4 for the rectangular basin, 1.28 for the trapezoidal basin, 1.22 for the elliptical basin, and 1.15 for the triangular basin.   اثر ساختگاه, اثر توپوگرافی, حوضه رسوبی, دره آبرفتی, بزرگ‌نمایی, ژئوتکنیک لرزه‌ای, حرکت حوزه آزاد, مرزهای جاذب انرژی, المان محدود Site Effects, Topographic effects, Sedimentary Basin, Alluvial valley, Amplification, Geotechnical earthquake, Free-Field Motion, Absorbing boundary, Finite Element. 345 372 http://jeg.khu.ac.ir/browse.php?a_code=A-10-27-3&slc_lang=fa&sid=1 Sassan Narimannejad ساسان نریمان‌نژاد 10031947532846002530 10031947532846002530 No دانشگاه خوارزمی، دانشکدۀ فنی مهندسی Alireza Jafari-Nedoshan علیرضا جعفری‌ندوشن 10031947532846002531 10031947532846002531 No دانشگاه خوارزمی، دانشکدۀ فنی مهندسی Ali Massumi علی معصومی 10031947532846002532 10031947532846002532 Yes دانشگاه خوارزمی، دانشکدۀ فنی مهندسی Abdollah Sohrabi-Bidar عبدالله سهرابی‌بیدار 10031947532846002533 10031947532846002533 No دانشگاه تهران، دانشکدۀ علوم زمین Ali Ghanbari1 علی قنبری 10031947532846002534 10031947532846002534 No دانشگاه خوارزمی، دانشکدۀ فنی مهندسی